![]() ![]() Open the sponges and place them in the rectangular compartments atop the toolbox.Plug the wand power cord into the back of the motor control box and into a power source. ![]() Plug the vacuum power cord into the vacuum suction controller (do not plug the wand motor into the vacuum suction controller).On the other hand, you may want to increase suction to quickly pull the leaf into the cutting slot for larger flowers, increasing your efficiency.Ģ.Remove the wand, motor, vacuum hose, vacuum suction controller and Velcro straps from the toolboxģ.Place the motor at one end of the table (on the right side if you are right-handed and the left side if you are left-handed)Ĥ.Attach the wand to the end of the flex shaft cable by aligning the keyed end of the cable with the key at the base of the wand in the drive hub housingĥ.Rotate the wand without pressing in to assist the keys alignmentĦ.Once the keys are aligned, continue rotating and press the wand down on the flex shaft until it clicks (the wand should rotate freely when it is connected to the cable)ħ.Install the open end of the vacuum hose to the vacuum hose attachment on the wand (the first few times may take a little more effort)Ĩ.Lay the vacuum hose along side the flex shaft cable and attach it to the flex shaft cable using the provided Velcro straps, attach a Velcro strap every 8-10 inches (zip ties can also be used)ĩ.Attach the other end of the vacuum to the hose on the wet/dry vacuum For smaller flowers, you may want lower suction to prevent the flowers from being pulled off the stem. Suction – The Wander Trimmer comes with a vacuum speed control that can be dialed up or down depending on the size of flowers you trim. Instead of bringing your cutting blade to the leaf, the Wander Trimmer brings the leaf to your cutting blade, significantly increasing the speed and quality of your trim. Like scissors, the Wander Trimmer gives you complete control of the cutting slot, allowing you to trim your leaf without damaging your flowers. Trimming with the Wander Trimmer truly is hand trimming. The Wander Trimmer provides a tight, consistent cut without nicking your flowers. Your undamaged, trimmed leaf is deposited into your bucket head shop vac for easy processing. The vacuum creates a suction that pulls the leaf away from the undisturbed flower and into the cutting slot, where the blade spins and cuts. It is a wet trimmer that allows you to trim up to 1 pound an hour (dry weight), will not damage your flower, collects all of your trim for processing, and still allows you to hang dry your plants. The Wander Trimmer provides the perfect combination of hand trimming precision with the efficiency of a trimming machine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |